Rule 500 25SA Submersible Bilge Pump

Description

The Rule 500SA is a fully automatic bilge pump incorporating new technology that eliminates the need for a mechanical float switch. Every 2 minutes the impeller is spun very briefly and a load sensor identifies if any water is present. If so the pump will run until there is no more resistance on the impeller. If not, the pump will rest for another 2 minutes before the process is repeated.

• Connections: For 19mm (3/4") bore hose.

• Dimensions: 107mm high, 64mm x 74mm.

• Output: Up to 31 litres/minute (7 gallons/minute) at 12V, without check valve. Max. recommended discharge head 2m.

• Fully automated bilge pump with computerised operation.

• Tough plastic body with integral strainer.

• Quick release strainer allows rapid cleaning.

• Low current draw helps minimise battery capacity consumption.

• Checks for water every 2 1/2 minutes (Runs for 1/2 second)

• Built-in Thermal Cut-Off.

• Check Valve included for Back Flow Prevention.

• Vented body to prevent air locking.

• Threaded port for easier installation and maintenance.

• No Need for separate float switch, third wire for manual override.

• Base not interchangeable with old range but can be fitted to existing screw holes.